ServeRAID M1000 Series SAS/SATA Controller Firmware Update Adapters Supported: ServeRAID M1115 SAS/SATA Controller for IBM System X (81Y4448) ServeRAID M1015 SAS/SATA Controller (46M0831) (C) Copyright International Business Machines Corporation 1999, 2014. All rights reserved. US Government Users Restricted Rights - Use, duplication, or disclosure restricted by GSA ADP Schedule Contract with IBM Corp. Note: Before using this information and the product it supports, read the general information in "Notices and trademarks" in this document. CONTENTS ________ 1.0 Overview 2.0 Installation and setup instructions 2.1 Standalone usage instructions 2.2 Troubleshooting tips 3.0 Configuration information 4.0 Unattended mode 5.0 Web site and support phone number 6.0 Notices and trademarks 7.0 Disclaimer 1.0 Overview _____________ 1.1 This update includes a new firmware update for the ServeRAID M1000 Series SAS/SATA Controller. 1.2 Limitations: - Rollback to previous firmware has only been verified for the following levels: 20.11.1-0184, 20.11.1-0137 and 20.10.1-0107. All other levels have not been verified. - Roll back to 12.7.0.xxxx or earlier will cause the controller to stop functioning. - Power save technology is not supported on any physical or logical drives. - VMware systems must run this update using IBM ToolsCenter Bootable Media Creator. 1.3 Problems fixed: - See change history 1.4 Level of Recommendations and Prerequisites for the update: - 32 bit glibc.i686, libstdc++.so and libncurses.so are required for the update run. Example: RHEL 6 install - libstdc++-4.4.4.13.el6.i686.rpm - ncurses-libs-5.7-3.20091208.el6.i686.rpm 1.5 Dependencies: - None 1.6 Update Contents o ibm_fw_sraidmr_1000-20.13.1-0254_linux_32-64.bin - The executable update package o ibm_fw_sraidmr_1000-20.13.1-0254_linux_32-64.chg - Change history 2.0 Installation and setup instructions ________________________________________ This package can be used with several of IBM's update management tools, including IBM UpdateXpress Manager, IBM UpdateXpress System Packs, IBM ToolsCenter Bootable Media Creator, and IBM Director. It can also be used as a standalone package. To use the package with one of IBM's update management tools, follow the instructions that came with your specific management tool. 2.1 Standalone usage instructions --------------------------------- Updating the local system: 1) Type "./ibm_fw_sraidmr_1000-20.13.1-0254_linux_32-64.bin -s" at a command prompt. 2) Reboot system for firmware to take effect. 2.2 Troubleshooting tips ------------------------ None 3.0 Configuration information ______________________________ For detailed setup instructions for your controller, refer to the documentation on the "ServeRAID MR Support" CD. 4.0 Unattended Mode ____________________ To run this package in unattended mode, use the following command: 1) ./ibm_fw_sraidmr_1000-20.13.1-0254_linux_32-64.bin -s 2) Reboot system for firmware to take effect. 5.0 Web Sites and Support Phone Number ______________________________________ o You can find support and downloads for IBM products from the IBM Support Web site: http://www.ibm.com/support/ You can find support and downloads specific to disk controllers by searching for the "Disk Controller and RAID Software Matrix" from the main support page. o For the latest compatibility information, see the IBM ServerProven Web site: http://www-03.ibm.com/servers/eserver/serverproven/compat/us/ o With the original purchase of an IBM hardware product, you have access to extensive support coverage. During the IBM hardware product warranty period, you may call the IBM HelpCenter (1-800-IBM-SERV in the U.S.) for hardware product assistance covered under the terms of the IBM hardware warranty. 6.0 Trademarks and Notices __________________________ IBM and ServeRAID are trademarks or registered trademarks of International Business Machines Corporation in the United States and other countries. LSI is a registered trademark of LSI Logic, Corp in the United States and other countries. Linux is a registered trademark of Linus Torvalds in the United States and other countries. Other company, product, and service names may be trademarks or service marks of others. 7.0 Disclaimer ______________ THIS DOCUMENT IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. IBM DISCLAIMS ALL WARRANTIES, WHETHER EXPRESS OR IMPLIED, INCLUDING WITHOUT LIMITATION, THE IMPLIED WARRANTIES OF FITNESS FOR A PARTICULAR PURPOSE AND MERCHANTABILITY WITH RESPECT TO THE INFORMATION IN THIS DOCUMENT. BY FURNISHING THIS DOCUMENT, IBM GRANTS NO LICENSES TO ANY PATENTS OR COPYRIGHTS. Note to U.S. Government Users -- Documentation related to restricted rights -- Use, duplication or disclosure is subject to restrictions set forth in GSA ADP Schedule Contract with IBM Corporation.